Test/Measure/Correct

At bottom of the form in page “Upload my recording”, depending on your plan, you can choose between some options :

  • “Test” gives the possibility to verify if the record is valid and if it will give correct measurements, see here.
  • “Measure” starts the analysis of uploaded file to write Measurement graphs.
  • “Measure and correct” adds calculation of FIR correction corresponding to your processor.
  • “New correction” keeps all values of the form, so you just change “Timbre target” and/or “LF target” to reprocess. You can change the record name and upload again so you will not rewrite on old corrections and keep possibility to compare.

Comment on this FAQ